View source for Contributions:CP2130Filter

==Synopsis==
The ''CP2130Filter'' allows for the interaction with Silicon Labs [https://www.silabs.com/documents/public/data-sheets/CP2130.pdf CP2130] board. This board uses a USB-SPI bridge that allows for commands to be sent to the board and data to be acquired from sensors.

To use this filter, a CP2130 board must be connected to the computer via USB. 

==Picture==
[[File:CP2130.jpg|300px]]

==Location==
http://{{SERVERNAME}}/svn/trunk/src/private/SignalProcessing/CP2130

==Versioning==
===Authors===
Yichuan Wang, Alex Belsten

===Source Code Revisions===
*Initial development: 5799
*Tested under: 5799
*Known to compile under: 5800
*Broken since: --

==Parameters==
===StimulationExpression===
Evaluated expression for the stimulation of ''StimulatingGPIO''. The default value ''State(MouseKeys)==1'' evaluates true when the left mouse key is clicked. Therefore, when the left mouse is clicked, ''StimulatingGPIO'' is stimulated. See [[User Reference:Expression Syntax]] for more details.
===StimulatingGPIO===
GPIO pin on the board that is stimulated. Default value is 0. Acceptable values range from 0-8.

==States==
===Temperature===
32 bit raw value from on-board temperature sensor
===Potentiometer===
32 bit raw value from on-board potentiometer
===InputADC===
32 bit raw value from on-board ADC input. Usefully for connecting to function generator.
==See also==
[[User Reference:Filters]], [[Contributions:SignalProcessing]]

[[Category:Contributions]][[Category:Signal Processing]][[Category:Filters]]